For use in solid concrete or grout filled masonry.
WEDGE-ALL Wedge Anchor
The Wedge-All is a non-bottom bearing, wedge style expansion anchor for use in solid concrete or grout filled masonry. A one-piece clip ensures uniform holding
capacity that increases as tension is applied. The
threaded stud version is available in nine diameters and multiple lengths. A single size tie-wire version is available for wire supported fixtures. Threaded studs are set by tightening the nut. Tie-wire anchors are set with the claw end of a hammer.
One piece wrap around clip
Threaded end is chamfered for ease of starting nut.
Most sizes feature full thread for added versatility.
Carbon and stainless steel.
Carbon steel anchors are available zinc plated or mechanically galvanized.
Meets requirements of Federal Specifications A-A-1923A, Type 4
The Load Tables list values based upon results from the most recent testing and may not reflect those in current code reports. Where code jurisdictions apply, consult the current reports for applicable load values.
The Wedge-All anchor has been tested in accordance with ICC-ES's Acceptance Criteria for Expansion Anchors in Concrete and Masonry Elements (AC01). ICC-ES report ESR-1396 recognizes the carbon and stainless steel Wedge-All for the following:
Static Tension and Shear Loading.
Seismic and Wind Loading.
Combination Tension and Shear Loading.
Critical and Minimum Edge Distance.
Length Identification Head Marks on Wedge-All Anchors
(corresponds to length of anchor – inches).
Wedge anchors shall be a threaded stud with an integral cone expander and a single piece expansion clip. The stud shall be carbon steel with a minimum 70,000 psi tensile strength, or type 303, 304 or 316 stainless steel, as called for on the drawings. Anchors shall meet Federal Specification A-A-1923A, Type 4. Anchors shall be Wedge-Alls from Simpson-Strong Tie, Pleasanton, CA. Anchors shall be installed following Simpson Strong-Tie's instructions for Wedge-Alls.
Hook Bolts and Anchors
Hook Bolts & Drop-In Anchors
Carbon Steel, Stainless Steel, Setting Tool The drop-in anchor is used in medium to heavy-duty applications in solid media such as concrete and stone.
A flush, female anchor, the drop-in houses an internal plug which is held securely in place even when used in overhead applications. Using the setting tool provided with each, causing the anchor to expand. Drop-ins are frequently used for over-head applications, including hanging pipe, duct work, machinery, etc. Drop-ins are available in carbon steel and 303 stainless steel.